X-ray Equipment – Radiology MCQ Questions and Study Notes
X-ray equipment produces controlled radiation to create diagnostic images. Practice free Radiology MCQ questions on this topic below.
Take the X-ray Equipment practice test All 8 chapters
Learning objectives
- Understand the key concepts of this chapter
- Apply them in safe practice
Study notes
The x-ray tube contains a cathode that releases electrons and an anode target that produces x-rays when struck. kVp controls beam energy and penetration, and mAs controls quantity of radiation.
The collimator limits the beam to the area of interest, reducing dose and scatter.
Important points
- kVp = quality/penetration
- mAs = quantity
- Collimate tightly
- Protect the patient
Key terms
Cathode Anode kVp mAs Collimator
Practice MCQs on X-ray Equipment
Tap “Show answer” to check each answer and read the explanation. These practice questions are written for learning with AI assistance and may contain mistakes. Please report any error so it can be fixed.
Questions 1 to 10
1. X-rays are produced when electrons strike the:
- Cathode
- Table
- Filter
- Anode
Show answer
Target.
2. kVp controls:
- Noise
- Time only
- Beam penetration
- Film size
Show answer
Beam energy.
3. mAs controls:
- Temperature
- Speed of tube
- Quantity of radiation
- Color
Show answer
Exposure amount.
4. A collimator:
- Adds dose
- Warms tube
- Prints image
- Limits the beam size
Show answer
Reduces scatter.
5. Electrons are released from the:
- Cathode
- Anode
- Grid
- Collimator
Show answer
Filament.
6. Tight collimation:
- Has no effect
- Reduces patient dose
- Blurs image only
- Increases dose
Show answer
Less scatter.
7. The X-ray tube housing is:
- Water-filled
- Always open
- Lead-lined and oil-cooled
- Made of plain plastic
Show answer
Protects from leakage radiation.
8. The tube filament is heated to release electrons by:
- Photoelectric effect
- Thermionic emission
- Compton effect
- Convection
Show answer
The cathode side.
9. A rotating anode helps to:
- Store images
- Lower the voltage
- Block scatter
- Spread the heat over a larger area
Show answer
Allows higher exposures.
10. A smaller focal spot gives:
- More dose
- Louder noise
- Blurrier images
- Sharper images
Show answer
But heats a smaller area.
Questions 11 to 20
11. The target of the anode is usually made of:
- Plastic
- Gold
- Tungsten
- Lead
Show answer
High melting point and atomic number.
12. Beam filtration removes:
- High-energy photons
- Low-energy photons that only add dose
- The patient's dose entirely
- Visible light
Show answer
Reduces patient dose.
13. An anti-scatter grid is placed:
- On the patient's skin
- Behind the generator
- Between the tube and the wall
- Between the patient and the image receptor
Show answer
Reduces scatter reaching the receptor.
14. Automatic exposure control (AEC) works by:
- Setting the table height
- Ending the exposure when enough radiation reaches the detector
- Cooling the tube
- Printing the image
Show answer
Needs correct positioning.
15. A digital radiography detector:
- Develops film in chemicals
- Records sound
- Measures heat
- Converts X-rays into a digital image
Show answer
Image appears in seconds.
16. Computed radiography uses:
- An imaging plate and a reader
- Wet film and chemicals
- Sound waves
- Magnets
Show answer
A digital step between film and DR.
17. PACS is a system to:
- Store and share medical images
- Cool the X-ray tube
- Position patients
- Measure dose
Show answer
Picture archiving and communication system.
18. DICOM is:
- A contrast agent
- A safety badge
- A standard format for medical images
- A type of X-ray tube
Show answer
Allows different devices to exchange images.
19. The exposure timer controls:
- The room lighting
- The table height
- How long the tube produces X-rays
- The patient's heartbeat
Show answer
Short times reduce motion blur.
20. The tube is warmed up before use to:
- Cool the room
- Charge the patient
- Clean the film
- Protect the anode from thermal shock
Show answer
Follow the manufacturer's routine.
Questions 21 to 21
21. Leakage radiation from the tube housing should be:
- Ignored
- Very low and checked in quality tests
- High
- Unmeasured
Show answer
A protection requirement.
Related chapters
- Previous: Radiation Physics
- Next: Radiographic Positioning
Continue learning
Radiology interview questions Mock tests MCQ practice
Frequently asked questions
How many X-ray Equipment MCQs are available?
This page has 21 free MCQs on X-ray Equipment with answers and explanations. More are added over time.
Is X-ray Equipment practice free?
Yes. You can practice without login or payment.
Are these official Radiology exam questions?
No. They are original practice questions written for learning.